You can print out the network settings of the machine such as its IP address and SSID.
Note: The steps listed below are specific to the MX410. For instructions for other models, click here
Important
-
Make sure that the machine is turned on.
-
Load a sheet of A4 or Letter-sized plain paper in the Rear Tray.
-
Press the Menu button repeatedly and select Device settings.
-
Use the
button to select LAN settings, then press the OK button.
-
Use the
button to select Print LAN details, then press the OK button.
The following information on the machine's network setting is printed out.
| Item | Explanations of the item | Setting |
| Wireless LAN | Wireless LAN | Enable/Disable |
| Link Status | Status of the Wireless LAN | Active/Inactive |
| MAC Address | MAC Address | XX:XX:XX:XX:XX:XX |
| SSID | SSID | SSID of the wireless LAN |
| Connection Mode | Connection Mode | Infrastructure |
| Channel | Channel | XX (1 to 13) |
| Encryption | Method of the Encryption | none/WEP/TKIP/AES |
| WEP Key Length | WEP Key Length | Inactive/128/64 |
| Authentication | Method of the Authentication | none/auto/open/shared/WPA-PSK/WPA2-PSK |
| Signal Strength | Signal Strength | 0 to 100 [%] |
| TCP/IP Version | TCP/IP Version | IPv4/IPv6 |
| IP Address | Selected IP Address | XXX.XXX.XXX.XXX |
| Default Gateway | Default Gateway | XXX.XXX.XXX.XXX |
| Subnet Mask*1 | Subnet Mask | XXX.XXX.XXX.XXX |
| Subnet Prefix Length*2 | Subnet Prefix Length | XXX |
| IPsec*3 | IPsec setting | Active |
| Security Protocol*3 | Method of the Security Protocol | ESP/ESP & AH/AH |
| Printer Name | Printer name | Printer name (Up to 15 characters) |
| WSD | WSD setting | Enable/Disable |
| WSD Timeout | Timeout | 1/5/10/15/20 [min] |
| LLTD | LLTD setting | Enable/Disable |
| LPR Protocol | LPR protocol setting | Enable/Disable |
| Bonjour | Bonjour setting | Enable/Disable |
| Bonjour Service Name | Bonjour service name | Bonjour service name (Up to 52 characters) |
| Bonjour LPR Service | Bonjour LPR service advertising | Enable/Disable |
| IP Address Filtering | IP Address Filtering | Enable/Disable |
("X" represents an alphanumeric character ranging from 0 to 9 and A to F.)
*1 Only when IPv4 is selected on IPv4/IPv6 setting, the status of the network is printed.
*2 Only when IPv6 is selected on IPv4/IPv6 setting, the status of the network is printed.
*3 Only when IPv6 is selected on IPv4/IPv6 setting and Active is selected on IPsec settings, the status of the network is printed.
