Salesforce

Printing the LAN details (network settings) - MX432 / MX439

Printable View
« Go Back

Information

 
TitlePrinting the LAN details (network settings) - MX432 / MX439
URL NameART137703
Description
This article explains how to print a Network Configuration Page for the PIXMA MX432 and MX439.  An example of this page is attached to this article.
Solution

Note: The steps listed below are specific to the MX432 and MX439 printers.  For instructions for other models, click here

Printing Out Network Setting Information

You can print out the network settings of the machine such as its IP address and SSID.

Important

  • This print out contains valuable information about your computer. Handle it with care.
     

  1. Make sure that the machine is turned on.
     

  2. Load a sheet of A4 or Letter-sized plain paper in the Rear Tray.
     

  3. Press the Setup button.
     

  4. Use the LEFT RIGHT button to select Device settings, then press the OK button.
     

  5. Use the LEFT RIGHT button to select LAN settings, then press the OK button.
     

  6. Use the LEFT RIGHT button to select Print LAN details, then press the OK button.
     

    The following information on the machine's network setting is printed out.
     

    Item

    Explanations of the item

    Setting

    Wireless LAN

    Wireless LAN

    Enable/Disable

    Link Status

    Status of the Wireless LAN

    Active/Inactive

    MAC Address

    MAC Address

    XX:XX:XX:XX:XX:XX

    SSID

    SSID

    SSID of the wireless LAN

    Connection Mode

    Connection Mode

    Infrastructure

    Channel

    Channel

    XX (1 to 13)

    Encryption

    Method of the Encryption

    none/WEP/TKIP/AES

    WEP Key Length

    WEP Key Length

    Inactive/128/64

    Authentication

    Method of the Authentication

    none/auto/open/shared/WPA-PSK/WPA2-PSK

    Signal Strength

    Signal Strength

    0 to 100 [%]

    TCP/IP Version

    TCP/IP Version

    IPv4/IPv6

    IP Address

    Selected IP Address

    XXX.XXX.XXX.XXX

    Default Gateway

    Default Gateway

    XXX.XXX.XXX.XXX

    Subnet Mask*1

    Subnet Mask

    XXX.XXX.XXX.XXX

    Subnet Prefix Length*2

    Subnet Prefix Length

    XXX

    IPsec*3

    IPsec setting

    Active

    Security Protocol*3

    Method of the Security Protocol

    ESP/ESP & AH/AH

    Printer Name

    Printer name

    Printer name (Up to 15 characters)

    WSD

    WSD setting

    Enable/Disable

    WSD Timeout

    Timeout

    1/5/10/15/20 [min]

    LPR Protocol

    LPR protocol setting

    Enable/Disable

    Bonjour

    Bonjour setting

    Enable/Disable

    Bonjour Service Name

    Bonjour service name

    Bonjour service name (Up to 52 characters)

    IP Address FilteringIP Address FilteringEnable/Disable


    ("X" represents an alphanumeric characters.)

    *1 Only when IPv4 is selected for TCP/IP settings, the status of the network is printed.

    *2 Only when IPv6 is selected on TCP/IP settings, the status of the network is printed.

    *3 Only when IPv6 is selected on TCP/IP settings and Active is selected on IPsec settings, the status of the network is printed.

 

Page top

Powered by