**To change print settings, first access the machine's Device Settings.
Available Print Settings:
-
Prevent paper abrasion
Use this setting only if the print surface becomes smudged.
Important
-
Extended copy amount
Selects the amount of image that extends off the paper when printing in borderless (full).
Slight cropping may occur at the edges since the copied image is enlarged to fill the whole page. You can change the width to be cropped from the borders of the original image as needed.
Important
-
This setting can be applied under the following conditions:
- Performing borderless copying
- Borderless is selected for Border when copying printed photos
Note
-
Adjust disc print area
You can adjust the disc printing area if the image is not aligned with the printable disc.
You can adjust the printing area in increments of 0.003 inches/0.1 mm between -0.03 inches/-0.9 mm and +0.03 inches/+0.9 mm.
-
Auto photo fix setting
When ON is selected, you can select whether to print photos using the Exif information recorded in the image files in the following cases.
-
Auto photo fix is selected for Photo fix when printing from a memory card.
-
The print setting on the PictBridge (Wireless LAN) compliant device is set to Default* or On when printing with a PictBridge (Wireless LAN) compliant device.
* When Default is selected for the print setting on the PictBridge (Wireless LAN) compliant device, select Auto photo fix for Photo fix in PictBridge print settings.
-
Adjust horizontal print position
Adjusts the print position when the left/right margins are not aligned.
You can adjust the left/right margins in increments of 0.01 inch/0.1 mm between -0.12 inch/-3 mm and +0.12 inch/+3 mm centered on the horizontal center of the paper.
Important
TS8120 Page
