EOS MOVIE Plugin-E1 for Final Cut Pro 1.5: The EOS Digital Rebel Series cameras are not compatible with EOS MOVIE Plugin-E1 for Final Cut Pro. The following software must be installed on the PC - Final Cut Pro 6.0.6 - Final Cut Pro 7.0.3 and later NOTE: Final Cut Pro X is NOT supported by this plugin.
With the camera turned off, open the cover. With the smaller plug of the included interface cable in the orientation shown, insert the plug fully into the camera terminal .
This section provides step-by-step procedures for transferring newly captured images from the camera to a computer. 1. Connect the camera's digital terminal and the Macintosh's USB terminal with the supplied interface cable DIGITAL terminal on the camera
What are the system requirements to install and operate the software on a Macintosh - USB Mounter: 5 MB or more - Canon Camera Plug-In Module : 15 MB or more - Canon CP-10 Printer Driver: 3.8 MB or more (space required for installation)
Refer to the following explanation if images cannot be successfully downloaded to the computer using EOS Utility. The Cause and Meaning of the Error Message The following problem is a possible cause of the [There are no images in the camera or memory card that match download conditions] message being displayed after clicking the [Starts to download images] button in EOS Utility.
8. Connect the other end of the USB cable to the < A/V OUT / DIGITAL > terminal on the camera . 9. Set the camera's power switch to <ON>. 10. EOS Utility opens and the communications between the camera and the computer start.