| Search Results |
 |
BJC-4550 Error Codes - Beeping Flashing Lights
|
Error ConditionsERROR CONDITION BEEPS POWER ERROR RECOVERABLE BY USER Paper pick-up error 1 ... 0 Paper jam error 2 ... 0 BJ cartridge detection* 1 ... 0 UNRECOVERABLE BY USER RAM error 1 1 1 ROM error 2 1 1 Home position error 4 1 1 Waste ink full error 5 1 1 Temperature sensor error 6 1 1 Printing position correction error 8 1 1 Cleaning error 10 1 1
|
|
|
Check the ink cartridge and driver settings (Windows 95/98 and Windows Me)
|
Follow the suggestions below to resolve the issue. 1. Make sure the printer is powered on and that no error conditions exist (flashing lights or beeps).
|
|
|
Rendering Subsystems may be causing a 'Windows was unable to print the test page' error
|
Rendering Subsystems may be causing a 'Windows was unable to print the test page' error Symptoms: This problem manifests itself in two different manners: 1) Attempting to print from any applications in Win95 does not produce any results: no error messages , no printout, nothing at all.
|
|
|
Reseat or replace the ink cartridge
|
|
Check the parallel port connection and settings
|
You may use the following instructions as a guideline to resolve the issue: Reboot your computer and reset the printer. You can reset the printer by unplugging the printer for 30 seconds while it is still powered on, then plug the unit back into the power source and press the POWER button.
|
|
|
Printing the Test Pages From the Printer
|
Printing the Test Pages Using the Operator Panel Press and hold the POWER button until you hear the number of beeps that correspond to the test page you want to print.
|
|
|
How to Perform Print Head Cleanings
|
How to Perform Print Head Cleanings Make sure printer is turned on. Press and hold the RESUME button for at least two seconds until the printer beeps twice. The POWER light will blink for several seconds while the print head is being cleaned.
|
|
|
Verify the Ink Cartridge is Working Properly BJC-4100 / BJC-4200 / BJC4300 / BJC-4400
|
Printer attempts to print but no ink is on the paper. Perform a Nozzle test: Make sure printer is powered off. Press and hold down the Power button until the printer beeps four times
|
|
|
Check the ink cartridge status and settings
|
Solutions To perform the status test: Make sure the printer is off but plugged in, and has paper loaded. Hold down the power button until the printer beeps 3 times then release the power button. The printer should print a status page.
|
|
|
Using the BJ Setup Utility
|
Using the BJ Setup Utility The BJ Setup Utility may be used to enable, disable, or change a large number of printer functions. Among these are the "Automatic Power ON" and "Automatic Power OFF" features as well as the printer emulation (BJ/LQ).
|
|
