Ask a Question
FiltersClear
CMS-CATEGORY_REF
CANON (20)
Content Source
Articles (20)
Connection Type
Wireless (8)
Products
Flashes (20)
Speedlite 600EX II-RT (1)
Speedlite 580EX II (4)
Speedlite 470EX-AI (1)
Speedlite 550EX (3)
Macro Twin Lite MT-26EX-RT (2)
Speedlite 430EX II (2)
Speedlite 320EX (2)
Speedlite 270EX II (2)
600EX-RT Speedlite (1)
Speedlite Transmitter ST-E3-RT (1)
Macro Ring Lite MR-14EX II (1)
Speedlite 580EX (3)
 
 
Pages [Next]
Search Results
CMS-XML QuickGuide to Speedlite Transmitter ST-E3-RT Setup
The sender and receiver units must be set to same ID number . The number you set must be different from that of any other 600EX-RT shooter in the vicinity.
CMS-XML QuickGuide to Speedlite 600EX-RT Radio Wireless Flash Setup
You can enter any number from 0000 – 9999. The sender and receiver units must be set to same ID number . The number you set must be different from that of any other 600EX-RT shooter in the vicinity.
CMS-XML QuickGuide to Canon Integrated Speedlite Transmitter Operation
3. Press the Zoom button again until the "SLAVE" and ID number blink. Use the + or – buttons to dial-in group A, B or C. Press the Speedlite SET button to complete.
CMS-XML 550EX Speedlite : How to prevent the sender unit from firing its flash.
This setting is called "sender Flash ON" This setting automatically sets the sender unit's receiver ID to A
CMS-XML 550EX Speedlite : How to set up wireless E-TTL Autoflash with Flash Ratio ON.
As shown in the figure below, the wireless E-TTL autoflash system described as an example consists of a sender unit set to sender flash OFF and two receiver units. The receiver ID of the receiver unit on the camera's left is A The receiver ID of the receiver unit on the camera's right is B
CMS-XML 580EX II Speedlite : How to use the Metered Manual Flash Exposures.
Focus manually 3. Setup an 18% gray card Place the gray card at the subject's position
CMS-XML 580EX Speedlite : How to set flash ratio with E-TTL II.
The example below has two receiver units and the sender unit disabled from firing. Setting the receiver Units Two receiver units can be assigned to different receiver groups by setting a receiver ID .
CMS-XML 580EX Speedlite : How to set and use wireless flash with three receiver groups.
Set the receiver units Set the receiver unit's ID to <A>, <B>, <C> For receiver <C>, also set the exposure compensation as necessary
CMS-XML 580EX Speedlite : How to set the flash output for each receiver unit.
button The receiver ID <A> blinks Turn the
CMS-XML How to set the communication channel on the 430EX II Speedlite.
Set the receiver ID .
Pages [Next]