| Search Results |
 |
EOS R3: Specifications
|
Specifications ... image quality of 8 , ISO 100 ... ... image quality of 8 , ISO 100 ... 8 min. ... 46 hr. 23 min. 23 min. 8 min. 8 min. 8 bit / 10 ... 8 bit 23 mm eyepoint) Approx. 23 mm (at ... X -sync speed ... –1/ 8 * sec. ... 5 pins for X -sync and ... + 23 °C / ... + 23 °C / ... Approx. 8 hr. + 23 °C / ... + 23 °C / ... + 23 °C / ... + 23 °C / 73°F ... + 23 °C / 73°F ... Error correction functions using multiple MICHIBIKI satellites are not supported.
|
|
|
EOS R3: Troubleshooting
|
Responding to Error Messages Responding to error messages 21– 23 Also check the following points when responding to errors numbered 21–23. Are the camera and the access point set to use the same password for authentication?
|
|
|
EOS R3: Error Codes
|
|
EOS R3: Reference
|
Reference Troubleshooting Guide Error Codes ISO Speed in Movie Recording
|
|
|
EOS R3: Battery Information
|
Battery Information The shutter count is the number of still photos taken (not including movie recording). If a battery communication error message is displayed, follow the instructions in the message.
|
|
|
EOS R3: Dust Delete Data Acquisition
|
Preparation If the data is not obtained successfully, an error message will appear. Check the information in , select [OK
|
|
|
EOS R3: Inserting/Removing Cards
|
Removal If a card-related error message is displayed on the screen, remove and reinsert the card. If the error persists, use a different card.
|
|
|
EOS R3: Troubleshooting Guide
|
Troubleshooting Guide Inserting/Removing Cards Error Codes If a card error message is displayed, see and .
|
|
|
EOS R3: System Status Display
|
System Status Display Checking the Error Log Clearing the Camera Status Log
|
|
|
EOS R3: Syncing Time Between Cameras
|
Syncing Time Between Cameras You can set the sender camera time on up to 10 receiver cameras. Note that even after synchronization, a slight margin of error applies between sender and receiver camera time (of ±0.05 seconds, at most).
|
|
