Ask a Question
FiltersClear
CMS-CATEGORY_REF
CANON (9)
Content Source
Articles (9)
Products
PC150 (9)
 
 
Search Results
CMS-XML Allow the toner cartridge to adjust to the room temperature
To remove the possibility of condensation from the toner cartridge, leave it in the protective bag for two hours before inserting it in the copier.
CMS-XML General Specifications - PC 100 Series
Specifications Acceptable Originals Up to Letter (8 1/ 2 " x 11"), books and three-dimensional objects up to 4.4 lb Acceptable Copy Stock 15 lb to 32 lb bond plain paper, Canon type E transparencies, tracing paper, labels, colored paper, postcards and card stock up to 32 lb bond Copy Sizes
CMS-XML Cleaning the Copier-PC 100 Series
Cleaning the Copier To clean the underside of the platen glass, first remove the multi-stack tray from the main unit. To do so, hold the corners of the multi-stack tray with hands and lightly push inwards on the two corners to detach the tray.
CMS-XML Installation Precautions-PC 100 Series
Avoid direct sunlight and place in a cool location. 111 Relative Humidity of 25% to 75% Image quality may be affected by low temperatures if the copier has been left in a cold location, be sure to allow more than two hours for the copier to fully reach room temperature before using it.
CMS-XML Steam Is Emitted from the Printer Output Area (imageCLASS and Faxphone)
To help paper avoid moisture or dryness, keep paper in its wrapper until it is ready to be used.
CMS-XML Replacing and Storing Cartridges-PC 100 Series
Canon E20 Cartridge: approx. 2 ,000 copies of an A4-size, standard original
CMS-XML Canon Toner Cartridge Limited Warranty
To obtain the shipping address of Canon U.S.A, Inc. or Canon Canada, Inc., please call the Canon U.S.A., Inc. Help Desk at 1-800-828-4040 or Canon Canada Technical Support at 1-800-OK-CANON. Shipping charges, if any, must be prepaid.
CMS-XML Installation Procedure-PC 100 Series
Installation Procedure If the copier is brought in from a cold place to a warm one, or if the location of the copier should be rapidly heated, condensation will form inside the copier. This may adversely affect the quality of the copy image (e.g. blacked-out copies). When the copier is exposed to such conditions, allow at least two hours for the copier to adjust to room temperature before attempting to operate it.
CMS-XML Copying onto Postcards, Transparencies and Other Stock-PC 100 Series
If transparencies do not feed smoothly Hold the rear end of the two sheets as shown and insert them into the multi-stack tray. While holding the rear edge of the sheets, press the key.