| Search Results |
 |
Operating the Camera in Mobile Camera Viewer
|
|
Mobile Camera Viewer - Operating the Camera
|
|
Adjust the focus manually or press the <AF> button on the wireless controller VC-C50i / VC-C50iR
|
If a preset position is restored when the camera is in manual focus mode, the camera may be out of focus once it has moved to the preset position. Adjust the focus manually or press the button on the wireless controller to switch to auto-focus.
|
|
|
Privacy Mask Setting Tool
|
A tool that lets you cover certain areas on the camera image with privacy masks. When the camera is panned, tilted, or zoomed, the privacy mask area responds to the camera image.
|
|
|
Camera Software
|
Camera Operations and Settings Camera operations are performed using the Camera Viewer/ Mobile Camera Viewer. Camera settings are specified from the Setting Page.
|
|
|
How to use the Panorama Creation Tool in the VB-C60 Software
|
This tool is used to create a panorama image displaying the full view of the area covered by VB-C60. When using VB-C60 Viewer to perform pan, tilt, or zoom as well as define presets, you can see, at a glance, which part of the entire viewing area is currently covered.
|
|
|
How to use the Panorama Creation Tool with the VB-C300
|
This tool is used to create a panorama image displaying the full view of the area covered by the VBC300. When using the NC Viewer to perform pan, tilt, or zoom as well as define presets, you can see, at a glance, which part of the entire viewing area is currently covered.
|
|
|
Installing the Camera (VB-H41 / VB-M40)
|
The following explains the procedures to install the camera on a ceiling using the Ceiling Mount Cover SS40-S-VB/SS40-B-VB (sold separately). Before installing the camera, set the IP address and other network information on the camera using the “VB Initial Setting Tool” on the Setup CD-ROM.
|
|
|
Reset the ID correctly or cancel ID mode operation. VC-C50i & VC-C50iR
|
Resetting the ID correctly or cancelling ID mode operation VC-C50i / VC-C50iR When multiple VC-C50i/VC-C50iR cameras are connected and installed, all the cameras in range of the wireless controller simultaneously perform the operations specified. In this situation, the cameras can be operated individually by assigning separate ID numbers to each camera beforehand and then specifying the desired ID number from the wireless controller. This is referred to as ID mode operation.
|
|
|
Operable range of the wireless controller WL-V5 for the VC-C50i and VC-C50iR
|
Operable range of the wireless controller WL-V5 for the VC-C50i and VC-C50iR Use the wireless controller within the range described below, facing it toward the sensor for the wireless controller. The operable range of the wireless controller varies depending on the amount of charge remaining in the batteries and interference from other objects.
|
|
