| Search Results |
 |
Error: You Do Not Have Required Privileges to Access Folder - IJ Scan Utility - Windows
|
Allow the scan utility to work through Windows Defender Follow steps 1 through 3 above. Scroll down to Controlled folder access , Allow an app through Controlled folder access
|
|
|
Error Codes for the DR-G2090, G2110, and G2140 scanners
|
Error [ P ***] Paper jammed in scanner Error [C***] Scanner cover is open Error [J***] Paper feed error detected Error [J***] A document was skewed Error [D***] A double paper-feed has occured Error [J*** ] Staple was detected Error [J***] Dust was detected Error [U***] The count does not match Error [E***] Scanner hardware problem
|
|
|
Selecting a Job and Scanning (P-215)
|
If you configure scanning conditions that consume a large amount of the computer's memory, scanning may stop because of insufficient memory. If an error message appears due to insufficient memory while scanning is in progress, exit the application, change the scanning conditions, and then try scanning again.
|
|
|
Scanning Procedure (P-215)
|
If you configure scanning conditions that require a large amount of the computer’s memory, scanning may be disabled. If an error message appears due to insufficient memory while scanning is in progress, exit the application and try scanning again using different scanning condition settings.
|
|
|
Common Problems and Solutions (P-215)
|
A high resolution (600dpi etc.) is specified for [Dots per inch]. If an error message appears due to insufficient memory while scanning is in progress, exit the application, change the scanning conditions (e.g. reduce the resolution or page size) and then try scanning again. In addition, the amount of memory used can be contained by turning off [Moire Reduction] and [Prevent Bleed Through / Remove Background] if they are set to on.
|
|
|
Error: Scan Mode is not Selected (CaptureOnTouch)
|
To correct this error , follow these steps to scan using CaptureOnTouch (v 3 or v4): 1 . Select the Document. ... 3 . Select the green "SCAN" button to initiate the scan sequence.
|
|
|
Error on computer screen: Double feed has been detected
|
"Double feed has been detected" error on your computer screen while attempting to scan. ... 1 . Unplug scanner from computer (or at the very least, close the scanner cover so that it's powered off). ... 3 . Plug the scanner back in (or open the scanner cover if you only closed it instead of unplugging it). ... If you are still receiving the double-feed error , then follow these steps: 1 . Uninstall the driver. ... 3 . Reboot the computer (without the scanner being plugged into it).
|
|
|
During scanning, an unknown error occurs.
|
If you receive an unknown error while scanning, it may be that the scanner is having trouble communicating with the computer. ... 1 . USB extension cables 2. USB cables other than the one provided 3 . Plugging the USB cable into a hub (or the front port of a desktop computer)
|
|
|
Error: Invalid Password when attempting to log into the ScanFront 400.
|
One reason you might be receiving this error is that you have a space in your password. To correct this, please change your password (to exclude spaces).
|
|
|
Error: No Document Found in Scanner.
|
This error can be caused by the failure to remove the packing material (small plastic orange clip (see Step 3 below)) from the pickup roller. Removing the orange clip from the pickup roller can correct his error.
|
|
