| Search Results |
 |
PIXMA / MAXIFY Products: Windows 10 / Windows 11 on ARM-Based Computers
|
PIXMA G G 1200 G 1220 G 1230 G 2200 G 2260 G 2270 G 320x G 326x G 3270 G 4200 G4210 G 4270 G 5020 G 6020 G 7020 PIXMA iP / iX
|
|
|
Where are the Mac Drivers for my Printer / Scanner? (CanoScan / PIXMA / MAXIFY)
|
|
"You do not have permission to open the application “Canon IJScanner###"" After Installing the ICA Driver on macOS 11.5 (PIXMA / MAXIFY / CanoScan)
|
This article explains what to do if you see the error "You do not have permission to open the application “Canon IJScanner###" when scanning after installing the ICA driver for your scanner or multifunction printer on macOS 11.5.
|
|
|
Resolve USB Connection Issues in Windows 11 - PIXMA / MAXIFY / PIXMA / iPF PRO / CanoScan
|
Master Setup (Full Driver & Software Packages) For some models, when setting up the printer via a USB cable, after the USB cable is connected, an error screen appears without the driver installed. [Workaround]
|
|
|
Inkjet Printer and Scanner Models Compatible with Windows 10 S
|
PIXMA G G 1200 G 1220 G 2200 G 2260 G 3200 G 3260 G 4200 G4210 G 5020 G 6020 G 7020 PIXMA iP / iX ... PIXMA / imagePROGRAF ... PIXMA MG ... PIXMA MP ... PIXMA MX ... PIXMA TR ... PIXMA TS
|
|
|
MP Navigator EX Crashes After Updating to macOS 10.13 0r later
|
error , or the program does not start or other errors in macOS follow the steps below. ... PIXMA MG PIXMA MP 5600F MG2120 MP250 9000F MG3100 Series MP280 LiDE 110 MG5120 LiDE 210 MG5220 PIXMA MX
|
|
|
Check Error Message on Control Panel (DR-G1130/G1100)
|
When document feeding is interrupted, an error message will appear on the display panel.
|
|
|
Error Codes for the DR-G2090, G2110, and G2140 scanners
|
When an error occurs in the scanner, you will see the following error message on the display panel.
|
|
|
Handling a Double Feed (DR-G1130/G1100)
|
Handling a Double Feed When a double feed is detected while scanning, the document pages for which double feeding was detected are ejected at the eject outlet, an error message appears on the Control Panel display, and feeding stops. When a double feed is detected, the following process occurs, and messages appear according to the Rapid Recovery System setting in the ISIS/TWAIN driver.
|
|
|
Count-Only Mode (DR-G1130/G1100)
|
Verify Scan The scanner compares the document page count obtained from the Count-Only mode (or entered manually) with the actual count of document pages scanned, and an error message is displayed if the two counts do not match.
|
|
