Salesforce

Connect Wirelessly With the WPS (Push Button Method) - PIXMA MG3520, MG3522

Printable View
« Go Back

Information

 
TitleConnect Wirelessly With the WPS (Push Button Method) - PIXMA MG3520, MG3522
URL NameART141985
Description
Learn how to connect your PIXMA MG3520 or MG3522 printer to your wireless network using WPS.
Solution

To connect your printer to the network with this method, your wireless router must have a WPS™ button on it. The WPS button is located either on the front or back panel of your router, but not all routers have this button. Refer to your router instructions for additional help. 

If your router doesn't have a WPS button on it, you can use the cableless setup method.
 

Connect your printer to the network

 Locate the WPS button on your router before you begin.

  1. Make sure the printer is turned ON. The green POWER light (A) is lit if the power is ON.

    Printer panel with green power lamp (A) lit

  2. Hold down the Wi-Fi® button (B) on the printer until the orange light (C) flashes once, then release the Wi-Fi button after the flash.

    Figure shows WiFi button (B) being pressed with orange light (C) flashing once
     

  3. Make sure the blue Wi-Fi light (D) on your printer flashes quickly and that the green POWER lamp is lit.

    Figure shows WiFi lamp (D) flashing quickly and green lamp on.

  4. Press and hold the WPS button on your router within two minutes of completing Step 3.

  5. Confirm that the blue Wi-Fi lamp and the green POWER lamp on your printer are lit.

    Figure shows blue and green lamps on and not flashing

  6. Wi-Fi setup is complete. You're ready to install the software.


If lights do not remain lit

When the blue Wi-Fi light and/or orange alarm light do not remain steadily lit, try these steps:

  1. Press the WPS button.

  2. Wait for several minutes, bring the printer and router closer to one another.

  3. Then repeat these setup steps from the beginning.


Troubleshoot setup completion issues

Note If the orange light remains illuminated while the blue Wi-Fi light flashes, it's an indication that the setup is incomplete. Fix these items to unblock the setup completion.

  • Press the WPS button on your router. Identify whether router security settings are blocking connection to the printer. Wait for a while then configure wireless connection settings again.

  • Restart the router (turn OFF, then turn it back ON).

  • Verify that the computer and router are configured.

  • Review the Wi-Fi network properties to confirm the wireless computer networking standards is implemented (IEEE802.11).

  • Check that both the router and printer are installed in open spaces where wireless communications are possible.

    Orange light stays illuminated while WiFi light flashes

If your product issue isn't resolved after following the steps above, or if you require additional help, please create or log in to your Canon Account to see your additional options.
Powered by