| Search Results |
 |
Fax Quick Tips - MP830
|
To assist you in finding an answer to your inquiry, some of our most referred-to articles have been categorized in this document. When you find an article that closely matches your inquiry, click on it to open it. Tips on setting up your fax machine The following articles will help you connect the fax to your phone line, program the date and time the fax name and phone number as well as selecting the right receive mode.
|
|
|
Enter outside dialing prefix before the fax number
|
Enter outside dialing prefix before the fax number .
|
|
|
Verify the fax number to send to is correct
|
Contact the party to receive the fax and verify the fax number .
|
|
|
Press Stop/Reset to clear the message and attempt to send a fax again (MP830)
|
Press to clear the message and attempt to send a fax again.
|
|
|
How to Test the Send and Receive Functions for Faxing
|
After you have connected the fax machine to your telephone line, you can now test to see if is ready to send and receive faxes . Here’s how:
|
|
|
Verify the remote fax machine is set to answer automatically
|
[BUSY/NO SIGNAL] will appear on the display (or #018 will appear on an Activity Report) for several reasons: The remote fax is not answering (disconnected, set to not answer automatically, memory is full, etc.). The fax number being dialed is incorrect. The fax number being dialed is busy.
|
|
|
Connect the fax to the correct phone line
|
This will occur if there are multiple lines and telephone jacks in the same location. Or if the telephone jack is wired for two lines. For example, line one is to be used for voice calls and line two is to receive faxes. Disconnect the fax machine from the telephone wall jack. Connect a known functioning single-line telephone directly to the telephone wall jack.
|
|
|
Fax sending methods MP830
|
Sending Methods The machine starts sending automatically after the document is scanned in. Note: Color sending is available only when the recipient's fax machine supports color faxing .
|
|
|
Sending a fax (memory send) from an MP830
|
Adjust the fax settings for optimum fax quality. Press <Color> for color sending, or <Black> for black & white sending. Sending a fax using the platen glass, a window will appear after the first document is scanned to scan another docuemt (press <Color> or <Black>) or to finish scanning and start sending (press <OK>). If additional documents need to be scanned from the platen glass, repeat step 5 c until all documents are scanned then press <OK> to start sending.
|
|
|
Configure the Silex C-6700WG Print Server Through a Wireless LAN
|
Configure Through a Wireless LAN fresh If this does not help , refer to the "Discovery Check List " section of Troubleshooting
|
|
